|This page is about the Japanese light tank I-Go Ko. For equipment of the same adoption year, see Type 89 (Disambiguation).
- 1 Description
- 2 General info
- 3 Armaments
- 4 Usage in battles
- 5 History
- 6 Media
- 7 See also
- 8 External links
It was introduced in Update 1.65 "Way of the Samurai" along with the rest of the initial Japanese Ground Forces Tree. While a slow infantry support tank, with little armour for tank combat, it comes equipped with a low velocity 57 mm cannon loaded with capable HEAT shells, able to lob high penetrating shells at close range and behind cover. Making for a challenging task for new tankers, it will serve as a trial by fire to learn positioning and shell trajectory with a glass cannon.
Survivability and armour
The armour on the I-Go Ko is lacking against contemporary enemies. With an armour thickness of less than 20 mm (aside from the spaced areas) all over, even large-calibre machine guns can penetrate the tank frontally. Not to mention, the front armour is only mildly sloped and presents a large target that can result in the vehicle being knocked out with a single penetration. It is recommended to not rely on your armour, nor advance on an enemy unless they are incapacitated (i.e. gunner or cannon knocked out).
- Rolled homogeneous armour
|17 mm (32°) Front glacis
| 17 mm Top
17 + 17 mm Bottom
| 17 mm (61°) Top
17 mm Bottom
| 17 mm (9°) Turret front
25 mm (10°) Gun mantlet
|15 mm (10-12°)
|15 mm (11°)
- Suspension wheels and tracks are both 15 mm thick.
|Max Speed (km/h)
|Engine power (horsepower)
|Power-to-weight ratio (hp/ton)
Much like the armour, the I-Go Ko leaves something to be desired in the mobility department. While the tank is reasonably mobile in close-quarters situations due to the good acceleration, the poor top speed will result in long trips across large maps and between capture points compared to other reserve tanks.
Modifications and economy
|57 mm Type 90
|Turret rotation speed (°/s)
|Reloading rate (seconds)
| Type of
|Penetration @ 0° Angle of Attack (mm)
|Type 92 APHE
|Type 3 HEAT
| Type of
| Fuse delay
| Fuse sensitivity
| Explosive mass
(TNT equivalent) (g)
|Type 92 APHE
|Type 3 HEAT
- Racks disappear after you've fired all shells in the rack.
- To minimize rack detonation, it is recommended to empty all the way to the 3rd rack with 49 (+51) shells.
The Type 91 machine gun is mounted in the hull with limited traverse. With a limited magazine capacity, slow traverse speed, and small calibre, this machine gun usually doesn't serve much use in combat except as a tool against open-topped SPAA or tank destroyers, or to ping enemies on the map for teammates to see. As is common with many Japanese tanks, the turret is not fitted with a forward facing coaxial machine gun, so this machine gun is the I-Go Ko's only other weapon option if the main gun is incapacitated.
|6.5 mm Type 91
Usage in battles
The Type 89b I-Go Ko, despite its rather tractor-esque look, is a mobile tank that could use its speed to get to an enemy's flanks and cause some serious damage. The 57 mm cannon is unfortunately rather pitiful even in Rank I, with a penetration value of between 20 to 30 mm with APHE at standard combat ranges. Therefore, it is usually best to catch enemies unaware and go for flanking shots against their weaker side armour by driving around, instead of directly toward them. The 57 mm low-velocity shell does have an advantage of a rather prominent parabolic trajectory so it is possible to lob shells over hills to hit unsuspecting enemies behind it.
The gun's poor penetration will change when using the High Explosive Anti-Tank (HEAT) shell. This shell has 55 mm of penetration at any range but still has considerable drop-off due to the low velocity of the gun. It's a good enough anti-everything shell that can penetrate most targets you will meet, especially those pesky French tanks, which tend to be quite well armoured. The Type 3 HEAT shell, fortunately, has just enough penetration to get through them, although it is generally recommended to try to aim for weak spots and be prepared for the shell to non-pen. This shell will also most likely destroy any truck or open-topped vehicle with a good hit.
Specific enemies worth noting:
Pretty much everything is a threat to this vehicle due to its mediocre mobility and poor armour. Fast vehicles like the M2A4, BT-5, A13 Mk I, and AMD.35 in particular are a difficult encounter; the I-Go Ko is reasonably fast at close quarters, but not that fast. The tank's sluggish turret traverse makes tracking a close target difficult and at long range the slow shells are difficult to aim precisely at a moving target. The 45mm 20-K gun that the commonly encountered BT series have can easily destroy you at any range with a well-aimed shot.
Vehicles with autocanons and heavy machine guns like the M2A2, GAZ-AAA (DShK), Pz.II C, and T-60, are the I-Go Ko's worst nightmare. Their high volume of fire and good mobility coupled with the I-Go Ko's lack of a coaxial or pintle-mounted MG puts the I-Go Ko at a large disadvantage. SPAAs generally should be considered by the I-Go Ko to be just as deadly, if not more so, than conventional tanks.
One more vehicle type to worry about is aircraft. Due to the tank's roof being thin, aircraft with anything more than a heavy machine gun will be able to penetrate the I-Go Ko. Some examples of these include the 12.7 mm-armed P-26A-34 M2 and F3F-2, and the 20 mm-armed He 112 A-0 and D.500.
Pros and cons
- Decent forward speed and good acceleration
- Parabolic trajectory lets you lob 57 mm rounds over hills
- APHE has a huge amount of explosive mass, especially for the calibre
- Type 3 HEAT shell has good damage output and can go through most tanks rather easily
- Great gun depression
- Shoulder-stabilized main gun which allows for stable shots at low speeds
- Very poor armour layout
- APHE shell struggles to penetrate many of the tanks it will face, even from the sides
- Slow turret and hull traverse speed
- Tall for a Rank I tank
- No coaxial machine gun in the turret, the bow machine gun only fires forwards in a limited arc
- Tight crew spacing, which can result in the I-Go Ko being knocked out in one shot
Japan's early pioneering into the concept of armoured warfare began as early as October 1918 during the first World War. They were able to acquire a few tank samples from the European governments, ranging from a British Mark IV tank, Medium A Whippet tanks, and Renault FT tanks. These tanks would make up Japan's first tank units in 1925. Their experiences with these tanks led to the eventual development of their own domestic tank design. The requirement for this new tank was given to the 4th Military Laboratory under the Imperial Japanese Army's jurisdiction and was mainly in charge of land vehicle development. In the summer of 1926, the first prototype was completed with the design of three turrets, one main in the middle and two smaller ones in the front and rear. The design was deemed too heavy at 18 tons and so development restarted, the initial design carrying on in the failed Type 91 and 95 tanks. During this time, a trial with a British Vickers Model C tank had the tank's gasoline engine catch fire. This prompted the Japanese to fit their tanks with a diesel engine instead. The development led to a new design in 1929, titled Type 89 I-Go. Though it is considered to be a light tank, the designation changed to a medium tank due to its weight of 10 tons.
The Type 89's construction was assigned to Sagami Arsenal, but it was subcontracted to private firms due to Sagami's lack in industry. One of the firms was Mitsubishi Heavy Industries, which developed a tank plant specifically for the Type 89. The Type 89 production officially started in 1931, with mass-production in 1933 and continued until 1939 with 404 tanks built.
The Type 89 I-Go was Japan's first domestic tank design, yet it showed a lot of features that were revolutionary and would become a trademark of the Japanese tank designs. The Type 89 I-Go had a four-man crew in the tank with two in the turret. The turret held a 57 mm low-velocity gun meant for fighting fortifications due to the tank's role as infantry support. A peculiar feature on the Type 89 was the rear machine gun on the back of the turret. This machine gun was meant to enable the Type 89 to engage forward targets with a machine gun or its 57 mm gun and would be a design trend in future tank development.
The Type 89 design changed gradually over time due to troop experience and advances in technology. For example, a small change that occurred for the Type 89 was the change of the commander's cupola from a "top hat" or "lid" design to a split hatch design. A noticeable change was in the engine when the first models produced off the lines were powered by a 118hp gasoline engine, these tanks were labelled as Type 89A I-Go Ko. It wasn't until 1934 when a change to 120hp Mitsubishi diesel engine was made that the Type 89 was redesignated the Type 89B I-Go Otsu. This diesel engine made the Type 89 the first mass-produced tank that uses diesel as its fuel.
The Type 89 does carry its few flaws, however. The tank was quite slow at about 25 km/h (16 mph), a hindrance to mobile operations using motorized infantry that must wait for the tanks to reach the combat zone. The armour was quite thin at 17 mm and the 57 mm's anti-tank power was quite abyssal. However, against the Chinese troops from 1932 onwards, the armour and firepower flaws were small worries due to the lack of available tanks and anti-tank defences on the Chinese side.
The Type 89 was first used in 1932 in the 1st Special Tank Company after the Manchurian Incident. The company, armed with Type 89 along with Renault FT and NC tanks, took part in the conflict between China and Japan in the Shanghai Incident. The experience showed that the Type 89 performed well in comparison to the Renaults and soon the entire company was fitted with Type 89s, retiring the Renaults.
The mass production of the Type 89 from 1933 onwards allowed the formation of large tank groups in Japan, leading to the 1st and 3rd Tank Regiment in Kurume, Fukuoka with the 2nd Tank Regiment at Chiba Tank School. The 1st Tank Regiment would be deployed with the Kwantung Army in China, where it would carry the Type 89 tank in the conflict against China from 1937 onwards.
By 1939, the Type 89 was starting to be succeeded by newer Japanese tanks, but they still served on the frontlines such as the border conflicts between Japan and the Soviet Union. In the Battle of Khalkhin Gol, the IJA's 1st Tank Corps attacked the Soviet 11th Tank and 7th Armoured brigades in July with a mixture of Type 89s, Type 97 mediums, Type 95 lights, and tankettes in the 3rd and 4th Tank Regiments. Though the attack stirred up Soviet lines, there was no breakthrough in Soviet lines. The Soviets, armed with T-26 and BT light tanks, would soon push the Japanese back to Manchuria and have a cease-fire signed on 24 August.
Though the Type 89 was mostly withdrawn from service and replaced with the Ha-Go and Chi-Ha, the I-Go still served as far into the battles for the Philippines, Malaya and Burma. Some tanks saw further use as static pillboxes in the Japanese islands of the Pacific, but these tanks were vulnerable to newer anti-tank and tank technology of the Americans with their bazookas and M4 Shermans once they started their island-hopping strategy against Imperial Japan.
Even after World War II, some Type 89s were still seen in service of the French during the First Indochina War, using the captured Japanese armour in a unit known as 'Commando Blindé du Cambodge'.
Many Type 89 relics still are visible in the wild usually reduced to a wreck with a handful of tanks still being in a good condition. These in good condition are located in:
- The Ordnance Training Support Facility, Ft. Lee, VA, USA.
- The Japanese Ground Self-Defense Force base at Tsuchiura, Ibaraki, Japan.
- Sinbudai Old Weapon Museum, Camp Asaka, Japan
- Villa Escudero, Tiaong, Quezon Province, Philippines
Only 1 I-Go Otsu remains in running condition, which was restored at the JGSDF base at Tsuchiura together with the last Type 3 Chi-Nu to still exist. Both are stored on military ground so aren't at all times in public display. The I-Go Otsu usually makes an appearance during the open day of the Tsuchiura base. The vehicle can be seen in media still running after being restored by the JGSDF.
Links to the articles on the War Thunder Wiki that you think will be useful for the reader, for example:
- reference to the series of the vehicles;
- links to approximate analogues of other nations and research trees.
- [Devblog] Type 89 I-Go Ko: First Series
- [Wikipedia] Type 89 I-Go medium tank
- [Tank Encyclopedia] Type 89 I-Go
- [Military Factory] Type 89 Chi-Ro
- Zaloga Steven. Japanese Tanks 1939-1945 Great Britain: Osprey Publishing Ltd., 2007
|Mitsubishi Heavy Industries ()
|Ha-Go · Ha-Go Commander
|Chi-Ha · Chi-Ha Kai
|Chi-He · Chi-He (5th Regiment)
|Chi-Nu · Chi-Nu II
|Chi-To · Chi-To Late
|Ho-Ri Prototype · Ho-Ri Production
|Na-To · Ro-Go Exp.
|␗Chi-Ha · ␗Chi-Ha Kai
|Most tank designs would be contracted by the Army Technical Bureau to Mitsubishi
|Mitsubishi Heavy Industries Ltd. (Post-War)
|Japan light tanks
|Ha-Go · Ha-Go Commander
|Type 87 RCV (P) · Type 87 RCV · Type 16 (P) · Type 16 (FPS) · Type 16
|▅M24 · ▅M41A1