From War Thunder Wiki
Revision as of 08:50, 17 August 2020 by Colok76286 (talk | contribs) (Ammunition: Added DM833 & corrected typo)

Jump to: navigation, search
10.0 10.0 10.0
Research:250 000 Specs-Card-Exp.png
Purchase:690 000 Specs-Card-Lion.png
Show in game
This page is about the American medium tank IPM1. For other vehicles of the family, see M1 Abrams (Family). For other uses of the designation, see M1 (Disambiguation).


GarageImage IPM1.jpg

The Tank, Combat, Full Tracked, 105-mm Gun IPM1, or just IPM1, is a rank VI American medium tank with a battle rating of 10.0 (AB/RB/SB). It was introduced in Update 1.81 "The Valkyries".

The IPM1 (Improved Performance M1) is a minor upgrade upon the protection of the M1 Abrams. This is primarily confined to improved composite protection in the turret cheeks, resulting in a slightly lengthened turret. The IPM1 maintains the same engine, weapon and other internals of the M1.

General info

Survivability and armour

The IPM1 maintains the protective measures and survivability of the original M1 Abrams, with the exception of a minor increase in the levels of composite protection. The result is a notable improvement in chemical protection and a minor improvement in kinetic protection. As with its predecessor, the turret cheeks and UFP are quite effective at deflecting ATGMs and HEAT rounds with only a few exceptions (such as the ADATS' 900 mm penetration missiles). Despite the improved protection, the IPM1 is still vulnerable to turret ring, gun mantlet and lower front plate shots, and particularly powerful kinetic rounds through the turret cheeks.

The Abrams' survivability comes not from armour, but rather from the spread-out crew members and critical components, and blowout panel protecting the crew from ammunition detonation. Often this results in enemies needing to make the choice of either disabling the vehicle's mobility or its offensive ability with their initial round; allowing the Abrams either to escape further damage or fire back.

Rounds that penetrate the rear panel between the turret crew compartment and blowout compartment will negate the blowout protection, causing any potential ammunition detonation to knock the vehicle's crew out as well.


Game Mode Max Speed (km/h) Weight (tons) Engine power (horsepower) Power-to-weight ratio (hp/ton)
Forward Reverse Stock Upgraded Stock Upgraded
Arcade 76 40 55.3 2058 2898 37.22 52.41
Realistic 68 36 1343 1519 24.29 27.47

The IPM1 retains the same engine as the original M1 Abrams with a minor increase (+0.9t) in weight due to the armour improvements. As such, the IPM1 suffers from a minimal reduction in top speed but will still comfortably reach 70km/h on-road. Despite the hugely powerful engine, the vehicle's manoeuvrability suffers prior to the Tracks upgrade being researched; once Tracks have been purchased the IPM1 will perform significantly better in close quarters or in off-road applications.

As with the original Abrams, the IPM1 largely relies on its powerful engine to get it to the battlefield earlier than other vehicles and into advantageous positions.


Main armament

Main article: M68A1 (105 mm)

Like its predecessor, the IPM1 is equipped with a reliable 105 mm M68A1 cannon, and also has access to the same ammunition. The 105mm cannon is somewhat sub-par relative to the weaponry other top rank vehicles are equipped with, but an experienced tanker can make use of the decent round ballistics and incredibly good reload speeds to quickly despatch targets. It's important to know what the cannon is capable of and where weak spots are on enemy vehicles, particularly when facing more modern vehicles such as the Leopard 2A5 and T-80U.

105 mm M68A1 Turret rotation speed (°/s) Reloading rate (seconds)
Mode Capacity Vertical Horizontal Stabilizer Stock Upgraded Full Expert Aced Stock Full Expert Aced
Arcade 55 -10°/+20° ±180° Two-plane 38.08 52.71 64.00 70.8 75.29 6.50 5.75 5.30 5.00
Realistic 23.8 28.0 34.0 37.6 40.0


Penetration statistics
Ammunition Type of
Penetration @ 0° Angle of Attack (mm)
10 m 100 m 500 m 1,000 m 1,500 m 2,000 m
M456A2 HEATFS 400 400 400 400 400 400
M393A2 HESH 127 127 127 127 127 127
M735 APFSDS 353 350 342 333 322 312
M774 APFSDS 357 355 347 338 328 319
M833 APFSDS 395 392 387 381 375 369
Shell details
Ammunition Type of
Mass (kg)
Fuse delay
Fuse sensitivity
Explosive Mass
(TNT equivalent) (g)
0% 50% 100%
M456A2 HEATFS 1,173 10.5 0.0 0.1 1,271 65° 72° 77°
M393A2 HESH 732 14.85 0.4 0.1 4,306 73° 77° 80°
M735 APFSDS 1,501 3.7 N/A N/A N/A 76° 77° 80°
M774 APFSDS 1,509 3.4 N/A N/A N/A 78° 80° 81°
M833 APFSDS 1,485 3.7 N/A N/A N/A 78° 80° 81°
Smoke shell characteristics
Ammunition Velocity
Mass (kg)
Screen radius
Screen deploy time
Screen hold time
Explosive Mass
(TNT equivalent) (g)
M416 730 11.4 20 5 25 50

Ammo racks

Last updated:

Ammo racks of the M1 Abrams.
rack empty
rack empty
rack empty
rack empty
55 33 (+22) 25 (+30) (+52) (+55) No

Blowout rack only: 45 (+10)

First ammo rack will replenish when not reloading

Machine guns

The IPM1 is equipped with no less than three machine guns - while most often these are only valuable for clearing obstacles or tagging enemy vehicles, on occasion they might prove valuable dealing with close air support or nearby helicopters, as well as some light vehicles.

Additionally, due to the barrage of rounds produced when all three machine guns are fired simultaneously, they can sometimes be used to obstruct an enemy vehicle's gun sight simply by shooting their main gun (AB/RB) or their optics (SB)

12.7 mm M2HB
Mount Capacity
(Belt capacity)
Rate of fire
Commander's cupola 1,000 (200) 576 -9°/+65° -160°/+180°
7.62 mm M240
Mount Capacity
(Belt capacity)
Rate of fire
Loader's cupola 1,400 (200) 750 -9°/+65° -77°/+135°
Coaxial 10,000 (200) 750 N/A N/A

Usage in battles

The IPM1 should primarily rely on its speed and reload time to quickly despatch enemies and move back into cover. Where possible, make flanking maneuvers or use the Abrams' mobility to get into forward positions with the intention to catch unsuspecting targets off. Be aware, however, that the Abrams is only marginally faster than vehicles like the Leopard 2K and T-80U.

When forced into open or ranged engagements, use cover to protect your hull; while the turret may provide insufficient protection keeping the hull safe will often allow you to move back into cover if hit or damaged and repair or relocate, rather than losing your mobility and ability to escape.


Tier Mobility Protection Firepower
I Tracks Parts Horizontal Drive M393A2 M735
II Suspension Brake System FPE Adjustment of Fire M416 Smoke grenade
III Filters Crew Replenishment Elevation Mechanism M774 NVD
IV Transmission Engine ESS Artillery Support Laser rangefinder M833

Pros and cons


  • Composite armour in turret cheeks and UFP are capable of stopping all but the most powerful chemical rounds and ATGMs
  • Has a very fast reload, 6.5 seconds stock down to 5.0 seconds aced
  • Very powerful engine, high top speed and good acceleration characteristics
  • Extremely good reverse speed
  • Fast turret traverse
  • Extremely fast gun elevation/depression
  • Well spread crew and critical components result in good survivability
  • Blowout compartment can save crew from some ammunition detonation cases
  • Array of machine guns, effective against CAS, nearby helicopters and some light vehicles


  • Armour provides suboptimal kinetic protection
  • The 105mm APFSDS rounds aren't particularly powerful; may struggle to penetrate some modern targets
  • Extra armour reduces top speed and acceleration
  • Extremely vulnerable gun mantlet and turret ring
  • Turbine engine is extremely loud, often audible from long distance and can be used to discern the direction of the vehicle
  • Has the slowest reverse speed of (36km/h RB) out of all Abrams with (41km/h RB).
  • Like with most Abrams series tanks, the engine deck is slightly raised, meaning that you will not be able to depress the gun over the rear of the tank.


Development: M1

With the cancellation of the MBT-70/XM-803 program in 1971, a new program to research and create prototypes for a main battle tank was created in 1972 known as the Main Battle Tank Task Force (MBTTF) at Fort Knox. General Motors and Chrysler were eventually selected to submit drafts and designs and by the end of 1973 there were scale mock-ups of the XM1 prototypes. The design was featured around the previously used 105 mm M68 gun along with a high powered engine for increased mobility.[1] It was decided to explore new types of composite armour, and the Chobham armour being developing in Britain at the time was examined although it was not used in the XM1 prototypes.[2] The XM1 was tested in 1976, and by the end of the year Chrysler was chosen to create extensive engineering test vehicles.[3]

Testing of the Full Scale Engineering Development (FSED) prototypes took place in 1978 and 1979 with 11 vehicles being produced. By this time the Honeywell AGT-1500 gas turbine engine was installed. After successful modifications and testing, initial production was approved in 1979 for a series of 110 units.[4] Following more testing and finalization, production of the standardized 105 mm Gun Tank, M1 Abrams was approved in 1981, with the production run lasting until January 1985 and over 2,300 vehicles being made.[5]

Development: IPM1

The 105 mm Gun Tank M1, Improved Performance was a modification of the original M1 Abrams tank that was produced between October 1984 through May 1986 with a total of 894 vehicles being produced. The changes made to create the Improved Performance models were taken from the ongoing Block I development program for the M1 Abrams, which would eventually produce the M1A1. Additional NERA armour protection in the turret was added, an upgraded suspension and changes to the transmission gears all added substantial weight and the maximum speed was reduced from 45 to 41.5 mph (72.4 to 67.8 km/h). In addition, more stowage racks were added to the turret, which was elongated to fit the additional composite armour arrays.[6]


See also

  • M1 Abrams - Predecessor without the "Improved Performance" upgrades.

External links


  1. R.P. Hunnicut, "Abrams: A History of the American Main Battle Tank" (Novato: Presidio Press, 1990), pp. 161-162.
  2. Ibid., pp. 176-177.
  3. Ibid., p. 181.
  4. Ibid., pp. 195-202.
  5. Ibid., p. 216.
  6. Ibid., p. 230.

USA medium tanks
Early projects  M2
M3  M3 Lee · Grant I
M4  M4 · Calliope · M4A1 · M4A1 (76) W · M4A2 · M4A2 (76) W · M4A3 (76) W · M4A3 (105) · M4A5
M26  T20 · T25 · M26 · M26 T99 · M26E1
Post-war  M46 · M46 "Tiger" · M47 · M48A1 · T54E1 · T95E1
MBT  M60 · M60A1 (AOS) · M60A1 RISE (P) · M60A2 · M60A3 TTS · MBT-70 · XM-803
  XM-1 (Chrysler) · XM-1 (GM) · M1 Abrams · IPM1 · M1A1 Abrams · M1A2 Abrams
Israeli  Magach 3 · Merkava Mk.1 · Merkava Mk.2B · Merkava Mk.3D
Turkey  M60 AMBT