IPM1

IPM1

M1A1

M1A2 Abrams

IPM1

M1A1

M1A2 Abrams

USA

VII Rank

Battle rating:

AB	RB	SB
11.3	11.3	11.3

Class:

Medium tank

Research:175 000

Purchase:950 000

Show in game

This page is about the American medium tank IPM1. For other vehicles of the family, see M1 Abrams (Family). For other uses of the designation, see M1 (Disambiguation).

Description

The Tank, Combat, Full Tracked, 105-mm Gun IPM1, or just IPM1, is a rank VII American medium tank with a battle rating of 11.3 (AB/RB/SB). It was introduced in Update 1.81 "The Valkyries".

The IPM1 (Improved Performance M1) is a minor upgrade upon the protection of the M1 Abrams. This is primarily confined to improved composite protection in the turret cheeks, resulting in a slightly lengthened turret. The IPM1 maintains the same engine, weapon and other internals of the M1.

General info

Survivability and armour

The IPM1 maintains the protective measures and survivability of the original M1 Abrams, with the exception of a minor increase in the levels of composite protection. The result is a notable improvement in chemical protection and a minor improvement in kinetic protection. As with its predecessor, the turret cheeks and UFP are quite effective at deflecting ATGMs and HEAT rounds with only a few exceptions (such as the ADATS' 900 mm penetration missiles). Despite the improved protection, the IPM1 is still vulnerable to turret ring, gun mantlet and lower front plate shots, and particularly powerful kinetic rounds through the turret cheeks.

The Abrams' survivability comes not from armour, but rather from the spread-out crew members and critical components, and blowout panel protecting the crew from ammunition detonation. Often this results in enemies needing to make the choice of either disabling the vehicle's mobility or its offensive ability with their initial round; allowing the Abrams either to escape further damage or fire back.

Rounds that penetrate the rear panel between the turret crew compartment and blowout compartment will negate the blowout protection, causing any potential ammunition detonation to knock the vehicle's crew out as well.

Mobility

Game Mode	Max Speed (km/h)		Weight (tons)	Engine power (horsepower)		Power-to-weight ratio (hp/ton)
	Forward	Reverse		Stock	Upgraded	Stock	Upgraded
Arcade	76	43	56.8	2058	2,898	36.23	51.02
Realistic	69	39		1343	1,519	23.64	26.74

The IPM1 retains the same engine as the original M1 Abrams with a minor increase (+0.9t) in weight due to the armour improvements. As such, the IPM1 suffers from a minimal reduction in top speed but will still comfortably reach 70km/h on-road. Despite the hugely powerful engine, the vehicle's manoeuvrability suffers prior to the Tracks upgrade being researched; once Tracks have been purchased the IPM1 will perform significantly better in close quarters or in off-road applications.

As with the original Abrams, the IPM1 largely relies on its powerful engine to get it to the battlefield earlier than other vehicles and into advantageous positions.

Armaments

Main armament

Like its predecessor, the IPM1 is equipped with a reliable 105 mm M68A1 cannon, and also has access to the same ammunition. The 105mm cannon is somewhat sub-par relative to the weaponry other top rank vehicles are equipped with, but an experienced tanker can make use of the decent round ballistics and incredibly good reload speeds to quickly despatch targets. It's important to know what the cannon is capable of and where weak spots are on enemy vehicles, particularly when facing more modern vehicles such as the Leopard 2A5 and T-80U.

105 mm M68A1					Turret rotation speed (°/s)					Reloading rate (seconds)
Mode	Capacity	Vertical	Horizontal	Stabilizer	Stock	Upgraded	Full	Expert	Aced	Stock	Full	Expert	Aced
Arcade	55	-10°/+20°	±180°	Two-plane	38.08	52.71	64.00	70.8	75.29	6.50	5.75	5.30	5.00
Realistic					23.8	28.0	34.0	37.6	40.0

Ammunition

Penetration statistics
Ammunition	Type of warhead	Penetration @ 0° Angle of Attack (mm)
		10 m	100 m	500 m	1,000 m	1,500 m	2,000 m
M456A2	HEATFS	400	400	400	400	400	400
M393A2	HESH	127	127	127	127	127	127
M735	APFSDS	353	350	342	333	322	312
M774	APFSDS	357	355	347	338	328	319
M833	APFSDS	395	392	387	381	375	369

Shell details
Ammunition	Type of warhead	Velocity (m/s)	Projectile Mass (kg)	Fuse delay (m)	Fuse sensitivity (mm)	Explosive Mass (TNT equivalent) (g)	Ricochet
							0%	50%	100%
M456A2	HEATFS	1,173	10.5	0.0	0.1	1,271	65°	72°	77°
M393A2	HESH	732	14.85	0.4	0.1	4,306	73°	77°	80°
M735	APFSDS	1,501	3.7	N/A	N/A	N/A	76°	77°	80°
M774	APFSDS	1,509	3.4	N/A	N/A	N/A	78°	80°	81°
M833	APFSDS	1,485	3.7	N/A	N/A	N/A	78°	80°	81°

Smoke shell characteristics
Ammunition	Velocity (m/s)	Projectile Mass (kg)	Screen radius (m)	Screen deploy time (s)	Screen hold time (s)	Explosive Mass (TNT equivalent) (g)
M416	730	11.4	20	5	25	50

Ammo racks

Last updated: 1.77.2.68

Ammo racks of the M1 Abrams.

Full ammo	1st rack empty	2nd rack empty	3rd rack empty	4th rack empty	Visual discrepancy
55	33 (+22)	25 (+30)	3 (+52)	0 (+55)	No

Blowout rack only: 45 (+10)

First ammo rack will replenish when not reloading

Machine guns

The IPM1 is equipped with no less than three machine guns - while most often these are only valuable for clearing obstacles or tagging enemy vehicles, on occasion they might prove valuable dealing with close air support or nearby helicopters, as well as some light vehicles.

Additionally, due to the barrage of rounds produced when all three machine guns are fired simultaneously, they can sometimes be used to obstruct an enemy vehicle's gun sight simply by shooting their main gun (AB/RB) or their optics (SB)

12.7 mm M2HB
Mount	Capacity (Belt capacity)	Rate of fire (shots/minute)	Vertical guidance	Horizontal guidance
Commander's cupola	1,000 (200)	576	-9°/+65°	-160°/+180°

7.62 mm M240
Mount	Capacity (Belt capacity)	Rate of fire (shots/minute)	Vertical guidance	Horizontal guidance
Loader's cupola	1,400 (200)	750	-9°/+65°	-77°/+135°
Coaxial	10,000 (200)	750	N/A	N/A

Usage in battles

The IPM1 should primarily rely on its speed and reload time to quickly despatch enemies and move back into cover. Where possible, make flanking maneuvers or use the Abrams' mobility to get into forward positions with the intention to catch unsuspecting targets off. Be aware, however, that the Abrams is only marginally faster than vehicles like the Leopard 2K and T-80U.

When forced into open or ranged engagements, use cover to protect your hull; while the turret may provide insufficient protection keeping the hull safe will often allow you to move back into cover if hit or damaged and repair or relocate, rather than losing your mobility and ability to escape.

Modules

Tier	Mobility		Protection	Firepower
I	Tracks		Parts	Horizontal Drive	M393A2	M735
II	Suspension	Brake System	FPE	Adjustment of Fire	M416	Smoke grenade
III	Filters		Crew Replenishment	Elevation Mechanism	M774	NVD
IV	Transmission	Engine	ESS	Artillery Support	Laser rangefinder	M833

Pros and cons

Pros:

• Composite armour in turret cheeks and UFP are capable of stopping all but the most powerful chemical rounds and ATGMs
• Has a very fast reload, 6.5 seconds stock down to 5.0 seconds aced
• Very powerful engine, high top speed and good acceleration characteristics
• Extremely good reverse speed
• Fast turret traverse
• Extremely fast gun elevation/depression
• Well spread crew and critical components result in good survivability
• Blowout compartment can save crew from some ammunition detonation cases
• Array of machine guns, effective against CAS, nearby helicopters and some light vehicles

Cons:

• Armour provides suboptimal kinetic protection
• The 105mm APFSDS rounds aren't particularly powerful; may struggle to penetrate some modern targets
• Extra armour reduces top speed and acceleration
• Extremely vulnerable gun mantlet and turret ring
• Turbine engine is extremely loud, often audible from long distance and can be used to discern the direction of the vehicle
• Has the slowest reverse speed of (36km/h RB) out of all Abrams with (41km/h RB).
• Like with most Abrams series tanks, the engine deck is slightly raised, meaning that you will not be able to depress the gun over the rear of the tank.

History

Development IPM1

The 105 mm Gun Tank M1, Improved Performance was a modification of the original M1 Abrams tank that was produced between October 1984 through May 1986 with a total of 894 vehicles being produced. The changes made to create the Improved Performance models were taken from the ongoing Block I development program for the M1 Abrams, which would eventually produce the M1A1. Additional NERA armour protection in the turret was added, an upgraded suspension and changes to the transmission gears all added substantial weight and the maximum speed was reduced from 45 to 41.5 mph (72.4 to 67.8 km/h). In addition, more stowage racks were added to the turret, which was elongated to fit the additional composite armour arrays.

Media

Skins

• Skins and camouflages for the IPM1 from live.warthunder.com.

Videos

The Shooting Range #119 - Metal Beasts section at 06:57 discusses the IPM1. - Tactics & Strategy section at 09:41 discusses how to defeat the IPM1.

See also

• M1 Abrams - Predecessor without the "Improved Performance" upgrades.

External links

• [Devblog] To Minnesota for the “Abrams”
• Hunnicut, R.P. Abrams: A History of the American Main Battle Tank. Novato: Presidio Press, 1990.