Marder III H
6 km/h back44 km/h forward
6 km/h backSpeed
- 1 Description
- 2 General info
- 3 Armaments
- 4 Usage in the battles
- 5 History
- 6 Media
- 7 Read also
- 8 Sources
The PaK40/3 auf Sfl.38 Ausf. H (or Marder III H) is a rank II German tank destroyer with a battle rating of 3.0 (AB/RB/SB). It was introduced in Update 1.47 "Big Guns".
The Marder III H is a step above the basic Marder III. As it is in Germany's open - top tank destroyer line, it's calling card is its superb firepower; in fact, it has the most powerful gun for the battle rating 2.0 - 3.0 - 4.0 range - APCBC is almost always enough to penetrate and destroy any tank on the battlefield, and with APCR, it has the highest penetration of any tank for its battle rating range - even at battle rating 5.0 your gun will remain competitive.
The Marder III Ausf. H mounts a 75 mm gun slightly surpassing those on the late Panzer IV's, thus its only disadvantages are its weak armour and its open encasement.
Being a modified Pz.38(t) tank, it is one of the more mobile of the German tanks - nearly matching some Russian tanks. It has a better gun close-range wise and has better armour coverage, being curved to the sides, unlike the earlier Marder III.
Survivability and armour
- Rolled homogeneous armour
|Armour||Front (Slope angle)||Sides (Slope angle)||Rear||Roof|
|Hull|| 50 mm (19°) Front plate
12 mm (74°) Front glacis
50 mm (13°) Lower glacis
| 16 mm Upper
15 mm Lower
|15 mm||12 mm|
|Turret||11 + 8 mm (31°)||11 mm (8-9°)||N/A||N/A|
- Belly armour is 15 mm thick.
|Weight (tons)|| Add-on Armor
|Max speed (km/h)|
|Engine power (horsepower)|
|Power-to-weight ratio (hp/ton)|
|75 mm PaK 40/3 L46|
|Turret rotation speed (°/s)|
|Mode||Stock||Upgraded||Prior + Full crew||Prior + Expert qualif.||Prior + Ace qualif.|
|Reloading rate (seconds)|
|Stock||Prior + Full crew||Prior + Expert qualif.||Prior + Ace qualif.|
|Ammunition|| Type of
|Penetration in mm @ 90°|
|Ammunition|| Type of
Mass in kg
| Fuse delay
| Fuse sensitivity
| Explosive Mass in g
| Normalization At 30°
|38||37 (+1)||33 (+5)||29 (+9)||25 (+13)||17 (+21)||9 (+29)||1 (+37)||No|
Gun shield empty: 33 (+5)
|7.92 mm Vz.37|
|Capacity (Belt capacity)|| Fire rate
| Horizontal |
Usage in the battles
Since you are an unprotected tank from behind, try to be as far from the action as possible. If getting close to enemy tanks cannot be prevented (Urban maps, Allied retreat etc), then try to hide at least a part of your hull against a wall or rock.
Use the horizontal range of the Marder III H as much as possible - as a turret-less SPG, it has excellent - if not the best - gun traverse for any turret-less SPG. This tank destroyer can be penetrated easily; it has next to no armour at its battle rating. keep close to other tanks to prevent this in urban maps, and stay close to cover in other maps. Also, be careful when being targeted by Artillery; one close hit on your rear and you can be destroyed by shrapnel. Another important thing to take into account is the fact that ammunition is stored in the nearly unarmoured gun shield - nearly any vehicle in the game - with the notable exception of the GAZ-AAA (4M) - can penetrate this tank with ease. To get Ammunition out of the turret, bring only 32 shells, leaving the "turret" basically empty - 32 shells is more than enough. Another fact to take into account is that nearly all shells will over penetrate the "turret", with no damage, a crewman knocked out or 2.
The Marder III H's main APCBC shell, the PzGr 39, is good enough against most standard medium tank models like the M4 Sherman and T-34 at a front-on and slightly angled perspective. However, the penetration performance against sloped armour is only just enough for these circumstances, and extreme angling beyond a 60 degree angle of attack on those tank's part can bounce rounds heading towards their front glacis. This makes up-armoured models like the T-34E and T-34E STZ particularly dangerous as they can defeat the APCBC shell's sloped performance at even slight angles. The T-34E presents itself an enhanced side armour that can bounce shots while the T-34E STZ features enhanced front armour to bounce shots, so be sure to distinguish the two models for a better understanding on where to aim.
First off, the Marder III H is hull-breakable, which triggers when a 75mm+ size AP round strikes the gun breech, transmission, or engine block. It also triggers when a large HE or any size HEAT shell hits it. Due to this alteration, modifications that improves survival after getting hit are not as important, so get Tracks and Horizontal Drive first, then Adjustment of Fire, Elevation Mechanism, and the three mobility upgrades. Then you are free to get Parts/FPE, though one can invest in FPE to avoid a case of a stray shrapnel or aerial strike penetrating the engine deck and causing a fire without hull-breaking the vehicle.
Pros and cons
- Outstanding gun for its rank
- Armour that protects the crew from MG fire, but thin enough to allow normal AP rounds to over-penetrate
- Fairly small tank destroyer can hide behind most obstacles
- Good gun elevation
- Excellent horizontal arc of 30°, that allows hiding easily the tank
- Amazing penetration with APCR ammunition
- Vulnerable to HE rounds
- Not fully enclosed (Exposed crew)
- Bad gun depression
- Extremely high penetration that it often over penetrates most light tanks that it faces
After the start of Operation Barbarossa, the Wehrmacht found a very dire problem of the lack of a mobile anti-tank system and adequate anti-tank weapons, especially after the appearance of the Soviet T-34 and KV-1 tanks. The only mass-issued anti-tank was the 37 mm Pak 36 and the only mobile anti-tank system widely used was the Panzerjäger I with the Czech 47 mm anti-tank gun. Modifications to current vehicles in service was done to put more self-propelled anti-tank weapons into service, which created the Marder I from the French Lorraine, the Marder II from the Panzer IIs, and the Marder III from the Czech Panzer 38(t).
The Marder III, with the rest of the Marder series, gave Germany forces a self-propelled gun mounting a better gun than what was available on German tanks, such as the 75 mm Pak 40 or captured Soviet 76.2 mm guns chambered for the Pak 40 ammo. All of the Marders share a lack of armour for the crew, the top and rear of the vehicle is left exposed to mortar, shrapnel, or infantry weapons. This weakness is mitigated with the fact that the Marders is supposed to be anti-tank motor carriages that are to ambush incoming enemy tanks.
The Marder III Ausf. H uses the Panzer 38(t) as it was a design going obsolete, and new large German anti-tank weapons were being produced, so they mounted these guns onto the Panzer 38(t) first. The finished self-propelled mount had a higher silhouette than the Panzer 38(t), which left it more vulnerable, but had a 75 mm Pak 40 gun and withhold 38 rounds in the vehicle. A machine gun on the hull was retained for anti-infantry purposes.
The Marder III Ausf. H predecessor, simply named as the Marder III mounted a rechambered 76.2 gun instead of a Pak 40. Another variant created, the Ausf. M, featured a lower silhouette and a better-sloped armour and fighting compartment, despite only holding 27 rounds for the mounted Pak 40. A total of 3,472 Marder IIIs and its version was created or converted from Panzer 38(t) during its production life.
The Marder III Ausf. H fought on all front of the war, being produced from 1942 to 1945, with 450 Marder III Ausf. H with the Pak 40 converted and produced. Using the tested design of the Panzer 38(t), the Marder III experienced a reliable mechanical history and has a gun that could take out most allied tanks in the war. The vulnerability to the crew due to lack of armour was its most pressing issue, with only a front shield plate at most 15 mm thick and side plates that can't enclose the crew. This makes it as very poor assault vehicles or tank substitutes as the open top could allow infantry to easily kill the crew from hidden areas, despite that, it is sometimes repurposed to this role to the chagrin of the crew.
As its production was underway, Germany already had a few self-propelled assault weapons being produced such as the StuG III that could have the same anti-tank capabilities, yet was fully armoured, enclosing the crew inadequate armour. This obvious advantage over the open Marder series encouraged the development of a new kind of tank destroyer from the Panzer 38(t) with better armour, which will eventually create the Jagdpanzer 38(t). Despite that, the Marders continued to serve to the end of the war.
"An antitank vehicle designed by Alkett. The prototype was built in June, 1942. It was produced from November, 1942 to April, 1943 at the BMM factory. The Marder II Ausf.H was also rebuilt from damaged tanks at the Wehrmacht factory in Prilougi using cabins obtained from BMM.
Marder IIIs were used actively on all fronts of World War II. Most of them were used on the Eastern Front.
A total of 613 Marder III Ausf.H tank destroyers were produced."
An excellent addition to the article will be video guides, as well as screenshots from the game and photos.
Links to the articles on the War Thunder Wiki that you think will be useful for the reader, for example,
- reference to the series of the vehicles;
- links to approximate analogues of other nations and research trees.
Paste links to sources and external resources, such as:
- topic on the official game forum;
- other literature.
|Germany tank destroyers|
|Based on Pz.38(t)||Marder III · Marder III H · Jagdpanzer 38(t)|
|Based on Pz.I||Panzerjäger I|
|Based on Pz.II||15cm sIG 33 B Sfl|
|Based on Pz.III||StuG III A · StuG III F · StuG III G · StuH 42 G|
|Based on Pz.IV||Jagdpanzer IV · Panzer IV/70(V) · Panzer IV/70(A) · Brummbär · Dicker Max · Nashorn|
|Based on Pz.V||Jagdpanther · Bfw. Jagdpanther|
|Based on Pz.VI||Sturer Emil · Ferdinand · Jagdtiger|
|JPz 4-5 · Waffenträger · VFW · VT1-2|
|Wheeled||8,8 cm Flak 37 Sfl. · Sd.Kfz.234/3 · Sd.Kfz.234/4|
|Rocket/Missile||15 cm Pz.W.42 · RakJPz 2 · RakJPz 2 (HOT)|