Vickers Mk.7

Vickers Mk.7

VFM5

Vickers Mk.7

VFM5

Britain

VII Rank

Battle rating:

AB	RB	SB
10.7	10.7	10.7

Class:

Medium tank

Research:300 000

Purchase:830 000

Show in game

Description

The Vickers Mk.7 is a rank VII British medium tank with a battle rating of 10.7 (AB/RB/SB). It was introduced in Update 1.93 "Shark Attack".

General info

Survivability and armour

Describe armour protection. Note the most well protected and key weak areas. Appreciate the layout of modules as well as the number and location of crew members. Is the level of armour protection sufficient, is the placement of modules helpful for survival in combat? If necessary use a visual template to indicate the most secure and weak zones of the armour.

Armour	Front (Slope angle)	Sides	Rear	Roof
Hull	___ mm	___ mm Top ___ mm Bottom	___ mm	___ - ___ mm
Turret	___ - ___ mm Turret front ___ mm Gun mantlet	___ - ___ mm	___ - ___ mm	___ - ___ mm
Cupola	___ mm	___ mm	___ mm	___ mm

Notes:

Mobility

Game Mode	Max Speed (km/h)		Weight (tons)	Engine power (horsepower)		Power-to-weight ratio (hp/ton)
	Forward	Reverse		Stock	Upgraded	Stock	Upgraded
Arcade	81	37	54.6	2,032	2,862	37.22	52.42
Realistic	73	33		1,327	1,500	24.3	27.47

Armaments

Main armament

The Mk. 7 uses the same L11A5 120mm rifled gun that the Challenger I uses. Shell loadout is identical and works well for mid-Cold War era tanks such as the Type 90, Leopard 2A4, T-64/T-72/T-80B, etc., but may struggle when fighting more modern vehicles such as the Leopard 2A5, T-80U, Leclerc, etc.

120 mm L11A5					Turret rotation speed (°/s)					Reloading rate (seconds)
Mode	Capacity	Vertical	Horizontal	Stabilizer	Stock	Upgraded	Full	Expert	Aced	Stock	Full	Expert	Aced
Arcade	50	-10°/+20°	±180°	Two-plane	29.5	40.8	49.6	54.9	58.4	7.8	6.9	6.4	6.0
Realistic					18.4	21.7	26.4	29.1	31.0

Ammunition

Penetration statistics
Ammunition	Type of warhead	Penetration @ 0° Angle of Attack (mm)
		10 m	100 m	500 m	1,000 m	1,500 m	2,000 m
Shot L23	APFSDS	410	408	405	400	390	380
Shell L31A7	HESH	152	152	152	152	152	152
Shot L23A1	APFSDS	396	394	387	376	367	357

Shell details
Ammunition	Type of warhead	Velocity (m/s)	Projectile Mass (kg)	Fuse delay (m)	Fuse sensitivity (mm)	Explosive Mass (TNT equivalent) (g)	Ricochet
							0%	50%	100%
Shot L23	APFSDS	1,535	3.89	N/A	N/A	N/A	76°	77°	80°
Shell L31A7	HESH	670	17.1	0.4	0.1	6,560	73°	77°	80°
Shot L23A1	APFSDS	1,535	3.89	N/A	N/A	N/A	78°	80°	81°

Smoke shell characteristics
Ammunition	Velocity (m/s)	Projectile Mass (kg)	Screen radius (m)	Screen deploy time (s)	Screen hold time (s)	Explosive Mass (TNT equivalent) (g)
L34	670	17.1	20	5	25	50

Ammo racks

Ammo racks of the Vickers Mk.7

File:AmmoRacksVickersMk7Pt2.png

Ammo racks of the Vickers Mk. 7. Additional charges not visible in first image.

Full ammo	Ammo type	1st rack empty	2nd rack empty	3rd rack empty	4th rack empty	5th rack empty	6th rack empty	Visual discrepancy
50	Projectiles Propellants	47 (+3) 47 (+3)	15 (+35) 18 (+32)	10 (+40) 15 (+35)	7 (+43) 9 (+41)	1 (+49) 4 (+46)	N/A 1 (+49)	No

Notes:

• Due to British two stage ammunition, projectiles are marked with numbers (1, 2, etc.), and propellants are marked with numbers preceded by C (C1, C2, etc.).
• In the case of projectiles racks 1 and 4 and propellants racks C3 and C6, the first half are taken out first, and the second half at a later time, and are therefore referred to as two racks.

Machine guns

7.62 mm L8A2
Mount	Capacity (Belt)	Fire rate	Vertical	Horizontal
Coaxial	2,000 (200)	600	N/A	N/A

Usage in battles

Describe the tactics of playing in the vehicle, the features of using vehicles in the team and advice on tactics. Refrain from creating a "guide" - do not impose a single point of view but instead give the reader food for thought. Describe the most dangerous enemies and give recommendations on fighting them. If necessary, note the specifics of the game in different modes (AB, RB, SB).

Modules

Tier	Mobility		Protection	Firepower
I	Tracks		Parts	Horizontal Drive
II	Suspension	Brake System	FPE	Adjustment of Fire	NVD
III	Filters		Crew Replenishment	Elevation Mechanism	L34	Smoke grenade
IV	Transmission	Engine		Artillery Support	Shot L23A1	Laser rangefinder

Pros and cons

Summarise and briefly evaluate the vehicle in terms of its characteristics and combat effectiveness. Mark its pros and cons in a bulleted list. Try not to use more than 6 points for each of the characteristics. Avoid using categorical definitions such as "bad", "good" and the like - use substitutions with softer forms such as "inadequate" and "effective".

Pros:

Cons:

History

In the mid 1980's, Vickers Defence Systems developed a new MBT as a private venture to find a successor to the Challenger back in following official specifications. The Vickers Mk.7 is a further development of the earlier Vickers Mk.4 Valiant main battle tank. The tank was very similar to the Mk.4, using the same "Valiant" or universal turret that the Mk.4 used, but being built with a Leopard 2 chassis, along with an MTU engine supplied by Krauss-Maffei. The tank was never adopted into service by the British Army, but its design was used as a base for the Challenger II MBT. The Vickers Mk.7 tank was actively offered for export, however it also received no production orders from other countries. Therefore only one Vickers Mk.7 prototype has been built.

Despite its naming, the tank has no relation to the Mk.1 Vickers MBT sitting at rank V.

Devblog

Following the failure of the previous Mk. 4 Valiant project, Vickers continued work on their design, confident in its success. As a result, Vickers developed the Mk.7 tank in the late 1980s on the basis of the previous Mk.4, hoping that it could be seen as a potential replacement for the Challenger 1. The new Mk.7 featured the existing turret of the Mk.4, though fitted to a Leopard 2 chassis.

Contrary to expectations, the British armed forces didn't procure the Mk.7, and so, the focus shifted towards the export market, similarly as was the case with the Mk.4 Valiant. Vickers developed an improved version of the vehicle, capable of mounting a variety of different 120mm cannons, in an effort to attract foreign interest. However, the high cost of the Vickers Mk.7 achieved only the contrary, with potential foreign interest being lost to other, more economical designs on the market.

Additionally, by the end of the 1980s, Germany imposed a ban on military equipment sales to countries in unstable regions, mainly those in the Middle East. Vickers, using the German-built Leopard 2 chassis, was therefore prevented from making sales to the most promising potential buyer of the Mk.7 - the United Arab Emirates.

Due to the high production costs resulting in low foreign interest in the vehicle, as well as dependency on outside factors, further development of the Vickers Mk.7 was officially halted, with only a single prototype being built for testing. However, although the Vickers Mk.7 itself became, in the end, another failed project, much of the experiences gained during its development found use in the creation of the far more successful Challenger 2.

Media

The Shooting Range #175 - Metal Beasts section at 00:38 discusses the Vickers Mk.7.

See also

• Vickers MBT — The early little brother of the Mk.7.
• Challenger Mk.2 / Challenger Mk.3 — The predecessors.
• Challenger 2 — The production model.

External links

• [Devblog] Vickers Mk.7: The Steel Centaur