H-75A-1

H-75A-1

D.501

H-75A-4

H-75A-1

D.501

H-75A-4

France

I Rank

Battle rating:

AB	RB	SB
1.3	1.7	1.7

Class:

Fighter

Research:2 900

Purchase:700

Show in game

This page is about the French fighter H-75A-1. For other versions, see P-36 (Family).

Description

The H-75A-1 is a rank I French fighter with a battle rating of 1.3 (AB) and 1.7 (RB/SB). It was introduced in Update 1.75 "La Résistance".

In the early 1930s, the Curtiss-Wright Corporation began a private venture to build a fighter aircraft which was a revolutionary departure from earlier cloth-covered biplanes of World War I. This project aircraft under development was named the Curtiss Hawk Model 75 (later it would be known by P-36 Hawk, Hawk-75 – or just H-75 and Mohawk.) The P-36 was an all-metal monoplane (although the control surfaces were fabric-covered) with a 900 hp radial engine, enclosed cockpit, and retractable landing gear. Early fighter trials paired this fighter against the Seversky P-35A where it ultimately lost out.

Around the time of the late 1930s, the French Air Force was lacking in modern fighter aircraft and realized that the domestic production could not meet the needs of the country. In light of this, France looked to foreign producers and approached Curtiss to produce an export version of the P-36 (which they were excited about), which would be known as the H-75. The first contract purchase was dubbed H-75A-1, of which 100 were contracted for. In December 1938, the H-75A-1 fighters were routed to France where they were assembled and where minor changes were made, especially in regards to the armament, cockpit controls, and cockpit instruments.

As the geopolitical situation rapidly disintegrated in Europe, France pushed for a rush order for 100 Curtiss H-75A-2 versions. This model was an improvement over the A-1, specifically in regards to its additional weaponry and an improved motor. After the declaration of war with Germany, the French placed another order for the H-75A-3 versions of the aircraft, first arriving in March 1940. However, due to the German invasion of France, some of the shipment was sunk at sea, while the others were diverted to areas around North Africa for safekeeping. Similar to the A-3, the H-75A-4 only had a relatively small amount arrive in France, with the bulk of them being diverted to Great Britain as Mohawks.

The French H-75 aircraft continued to see combat throughout the war, both under the control of the Allied Free French Forces and the British and under the axis Finnish, who received captured French aircraft from the Germans to be used against the Soviets.

General info

Flight performance

The H-75A-1 is a relatively easy fighter aircraft to fly and requires only a relatively short space to both take-off and land. Due to the fantastically low wing loading rate of 23.9 lb/ft², this fighter is an excellent turning aircraft and, accompanied by a strong rudder, can spiral climb easily, especially during WEP cycles. This aircraft has the advantage of being both a turn fighter and a Boom & Zoom fighter, all depending on the situation, type of enemy aircraft, and mission type. The H-75A-1 will out-turn many fighters of its rank and can prove difficult to follow if attempting to shoot it down. The P-36A, P-36C, and H-75A-1 utilise the same engine, however with the extra two machine guns and associated ammunition, the H-75A-1 model lags slightly behind the A with flight characteristics. The difference is often not noticeable enough for the pilot to realize while manoeuvring the aircraft. The trade-off for more guns vs. a slightly hampered flight model is well worth it.

Characteristics	Max Speed (km/h at 3,810 m)		Max altitude (metres)	Turn time (seconds)		Rate of climb (metres/second)		Take-off run (metres)
	AB	RB		AB	RB	AB	RB
Stock	538	523	9555	21.7	22.2	7.6	7.6	343
Upgraded	584	560		20.4	21.0	14.6	10.6

Details

Features
Combat flaps	Take-off flaps	Landing flaps	Air brakes	Arrestor gear
✓	✓	✓	X	X

Limits
Wings (km/h)	Gear (km/h)	Flaps (km/h)			Max Static G
		Combat	Take-off	Landing	+	-
681	290	520	520	232	~12	~7

Optimal velocities (km/h)
Ailerons	Rudder	Elevators	Radiator
< 290	< 380	< 420	> 300

Survivability and armour

• 9.5 mm steel plate behind the pilot.

As with many early pre-war fighters, not much emphasis was put on the survivability of the aircraft. The best course of action was for the pilot to not let anyone get behind them. The H-75A-1's only sources of protection for the pilot is the engine block and the 9.5 mm steel plate (angled at 24° for the effective thickness of 13 mm). Given that there is no frontal armour, the engine block may be used to save the pilot at the expense of the engine, thus requiring the pilot to glide back to base if possible or to bailout. There are also two unprotected oil coolers which, if punctured, will cause the aircraft will leak oil until depleted eventually causing the engine to seize up.

Armaments

Offensive armament

The H-75A-1 is armed with:

• 2 x 7.5 mm Mle 38 machine guns (600 rpg = 1,200 total)
• 2 x 7.5 mm Mle 38 machine guns (500 rpg = 1,000 total)

Lacking the punch of the 12.7 mm, this fighter has to make do without the more powerful machine gun. Due to the wing-mounted machine guns, convergence is a factor to deal with with the optimal range being 100 - 200 m. Anything beyond this will still work, but the bullets significantly start losing their punch. The increase in armament increased the damage output ability of the fighter. Options in ammunition will allow the pilot to select the type best suited for their mission whether it be as an interceptor, ground target hunter, or a stealthy pounce aircraft.

Option 1 Configuration (optimal 200 - 400 m convergence)

• 7.5 mm x 4 = Universal rounds
• Universal rounds for the French aircraft have the most armour-piercing rounds coupled with tracer bullets than any other belt. The tracer rounds are important because of the ability to walk in the shots with the tracers (especially helpful in realistic and simulator battles where the aiming helper is not available for use) to the enemy aircraft.

7.5 mm ammunition

Belt Type	1st Round	2nd Round	3rd Round	4th Round	5th Round	6th Round
Default	T	Ball	Ball	Ball	I	AP
Universal	T	AP	AP	I	I
Tracers	IT	IT	IT	IT	IT
Stealth	AP	AP	I
T = Tracer bullet; Ball = Omni purpose bullet; I = Incendary bullet; AP = Armour piercing bullet; IT = Incendary-Tracer

This aircraft does not have the option to select any additional suspended armaments nor does it have any defensive weapons to counter any attackers.

Usage in battles

Energy retention lends this fighter to be a great zoomer, dropping in for a shot and then speeding back up to regain the energy advantage. With this aircraft having such a low stall speed; it makes a great fighter to practice rope-a-dope energy depletion manoeuvres. This requires the H-75-A1 pilot to bait another fighter into following them in a climb. As the attacker attempts to get guns on target, the pilot can start to spiral climb, causing the attacking aircraft to pull a tighter circle, hemorrhaging their energy. If done correctly, the attacking fighter will stall out and be completely helpless as they begin to fall back to the ground, allowing the H-75A-1 to roll over or Split-S and take out the stalled fighter below.

Most fighters are typically only good at one thing, whether it's turning, speed, or weapon systems. However, the H-75A-1 is good at two: speed and turning. This fighter has the ability to not only zoom attack but also turn fight competitively with most other aircraft. There are few aircraft (notably the A6M Zero fighters of the Imperial Japanese Navy or the Bf 109 of the German Luftwaffe) which may outshine while turning or climbing. However, when utilizing flaps and rudder while turning, the H-75A-1 can manoeuvre into some tight turns and gain a possibility to take down these foes.

Even with all of its power and mobility, the H-75A-1 is a relatively fragile aircraft. Without much armour, many of its critical systems are exposed and it will not take much, even from lower calibre machine guns, to cause fuel fires, oil leaks, and engine shutdowns, not to mention a knocked out pilot. Situational awareness is critical to potentially know not only where the targets are, but also the enemy aircraft which are manoeuvring into position and ready to pounce. The weakness of having such weak machine guns will require the pilot to get in close (50 – 200 m) to make the most of their shots count, as anywhere past 150 m, bullet penetration drops off considerably.

Manual Engine Control

MEC elements
Mixer	Pitch	Radiator			Supercharger	Turbocharger
		Oil	Water	Type
Not controllable	Controllable Not auto controlled	Not controllable Not auto controlled	Controllable Not auto controlled	Combined	Not controllable 1 gear	Not controllable

Modules

Tier	Flight performance		Survivability	Weaponry
I	Fuselage repair	Radiator		Offensive 7 mm
II		Compressor	Airframe
III	Wings repair	Engine		New 7 mm MGs
IV		Engine injection	Cover

Pros and cons

Pros:

• High climb rate, especially with war emergency power applied
• Impressive roll and turn rate, allowing for highly efficient Immelman and split-S manoeuvres
• Strong rudder, excels in wing-over and hammerhead stall manoeuvres
• Slow stall speed (about 55 mph or 88.5 km/h)
• Four machine guns (comparable to P-36C)

Cons:

• Armament is inadequate against bombers and other aircraft with rear-facing gunners
• Lack of adequate armour renders engine, fuel tanks, oil coolers and virtually defenceless

History

The P-36 Hawk began its life at Curtiss Aeroplane Company as a design in the early 1930s. A private venture by Curtiss, the project was headed up by Donovan A. Berlin, a former Northrop aircraft company engineer who was the principal designer and incorporated design portions of early Northrop designs. The P-36, at this time known as the X-17Y, was a stretch from the biplane years by utilizing an all-metal low-wing monoplane with fabric-covered control surfaces. This aircraft also featured retractable landing gear, which utilized a design put forward by Boeing Aircraft Company and required royalties to be paid to Boeing for every aircraft in which this landing gear was installed. Initial weapon load-outs included the standard 12.7 mm and 7.62 mm machine guns, both of which were mounted in the forward fuselage deck and fired through openings in the cowling, synchronized to fire through the propeller arc.

The initial flight took place in 1935 and when it was presented at a competition the next year, the competitor aircraft (Seversky SEV-2XP/P-35) was heavily damaged in transit. While Seversky took their aircraft back to perform repairs and modifications, Curtiss took the opportunity during this time to make some modifications of their own, and namely replacing the Wright XR-1670-5 twin-row air-cooled radial engine with the upgraded Write XR-1820-39 Cyclone radial. With the Seversky aircraft repaired, the competition was back on. Even though the Seversky aircraft underperformed and was more expensive than Curtis X-17Y, it was selected and an order of 77 aircraft were put in for, however later the Material Division of the USAAC contacted Curtis and put in an order for three examples as they were becoming nervous about Seversky's ability to deliver their aircraft on time. Curtiss worked on modifying the P-36 by again upgrading the motor and working on the cockpit, especially increasing the amount of area behind the cockpit where the pilot could see. During the 1937 competition, test pilots who piloted the P-36 all commented that the aircraft responded to pilot input favourable and at all speeds and even noted that it handled well on the ground while taxiing. With such a reaction from the test pilots, the USAAC put in an order for 210 P-36A fighters, which at that time was the largest single US military aircraft order since World War I.

As the P-36 fighters began to roll off the assembly line, they were shipped to US squadrons, however, problems developed with the aircraft which left them grounded while waiting repairs. The P-36 continued to have problems, however, four P-36A fighters stationed at Wheeler Air Field in Hawaii were able to get airborne and attach a flight of Nakajima B5N1 torpedo bombers, claiming two shot down and gaining the first US fighter aircraft "kills" of the Pacific War. Despite this action, the P-36 fighters were withdrawn from combat outfits and sent to training units for new pilots to train on. While the P-36 did not see much action with the U.S., it did see combat action while flown by other nations such as France and Finland where they put the little fighter to the test and were highly successful with it. 10 P-36A training fighters were transferred in 1942 to Brazil where they remained in service until 1954.

While the P-36 failed to initially secure a contract early on with the United States, the desperate French approached Curtiss to secure an export version of this fighter to beef up their armed forces. With a contract settled, the H-75A-1 was the first production batch of Hawk 75 aircraft built for France with around 100 built and delivered. Unfortunately, after hostilities began, many of these aircraft were captured during the fall of France and were shipped to other countries friendly with Germany and were considered challenging aircraft for the allies to fly against.

Media

War Thunder Realistic: H-75A-1 [The French Hawk!] - Jengar

War Thunder Air RB - H-75A-4 - Pint Sized Pugilist - Hairyfeet

See also

Related Development

• Curtiss P-36 and H-75 variations

Analogues of other nations

• Polikarpov I-180S
• Bloch M.B.150
• IAR-81C
• Mitsubishi A6M Zero
• Nakajima Ki-43
• Reggiane Re.2000

External links

• Militaryfactory.com website [Curtiss P-36 Hawk (Hawk 75 / Mohawk)]
• Aviationhistory.com website [The Curtiss P-36 Hawk]
• Joebaugher.com website [Curtiss P-36A]