Difference between revisions of "Panzerjager I"
(→Armaments: Updated values for Turret rotation speed and Reload speed tables.)
(→Ammunition: Updated shell penetration.)
|Line 131:||Line 131:|
| Pzgr.36(t) || APC ||
| Pzgr.36(t) || APC ||||||||||||
| Pzgr.40 || APCR || 103 || 102 || 73 || 49 || 32 || 22
| Pzgr.40 || APCR || 103 || 102 || 73 || 49 || 32 || 22
Revision as of 15:12, 5 August 2019
4 km/h back42 km/h forward
4 km/h backSpeed
The 4,7 cm Pak(t) auf Pz.I Ausf.B, otherwise known as the Panzerjäger I, is a Rank I German tank destroyer with a battle rating of 1.7. It was introduced in Update 1.57 "Battle March".
Survivability and armour
- Rolled homogeneous armour
|Armour||Front (Slope angle)||Sides (Slope angle)||Rear||Roof|
|Hull|| 13 mm (18°) Front plate
13 mm (72-75°) Front glacis
13 mm (26°) Lower glacis
|13 mm||13 mm||8 mm|
|Superstructure||14 mm (26°)||14 mm (15-18°)||N/A||N/A|
- Suspension wheels and bogies are 10 mm thick while the tracks are 15 mm thick.
Any enemies at this rank can pierce your armour. However, the biggest threats are the SPAA vehicles due to their higher rate of fire with effective weapons that will absolutely rip apart the vehicle. Airplanes too are a concern, and Artillery is very deadly.
|Weight (tons)|| Add-on Armor
|Max speed (km/h)|
|Engine power (horsepower)|
|Power-to-weight ratio (hp/ton)|
|47 mm Pak(t)(Sf.)|
|Turret rotation speed (°/s)|
|Mode||Stock||Upgraded||Prior + Full crew||Prior + Expert qualif.||Prior + Ace qualif.|
|Reloading rate (seconds)|
|Stock||Prior + Full crew||Prior + Expert qualif.||Prior + Ace qualif.|
|Ammunition|| Type of
|Penetration in mm @ 90°|
|Ammunition|| Type of
Mass in kg
| Fuse delay
| Fuse sensitivity
| Explosive Mass in g
| Normalization At 30°
|86||50 (+36)||38 (+48)||28 (+60)||10 (+76)||0 (+86)||Yes|
Usage in the battles
Although virtually unarmoured, it can be used in a head-on manner. However, this is not recommended. It is much better to snipe or ambush the enemy. Its gun may have a good Rate of Fire, but many other guns of its rank, such as the British 2 pounder, will reload faster than you. Your gun is extremely powerful for its rank, which means you will go through almost anything, so there is no need to throw yourself in front of the enemy.
While the gun can be sufficient and one-shot many enemies from light to medium tanks, more heavily armoured tanks will be a problem unless using the APCR ammunition. The common enemies to be concerned about are the B1 bis, B1 ter, and Matilda Mk II if the Panzerjaeger I is used as the highest-BR option in your lineup. The B1 bis is only frontally penetratable on the turret ring or the exposed breech of the hull-mounted 75mm. The B1 ter is only penetratable in flank shots with APCR or a very lucky turret ring hit. The Matilda is only frontally penetratable on the turret ring or demands use of APCR.
Pros and cons
- Large ammo reserve of 86 rounds
- Agile vehicle
- Good power-to-weight ratio (27.34 hp/ton in AB, 15.62 hp/ton in RB/SB)
- One of the best guns in Rank I, can penetrate most things it comes up against and destroy them in 1-2 penetrating hits due to HE filler
- Access to APCR ammunition for certain targets that the APC-HE cannot penetrate reliably
- Good ballistics for 47 mm, can be used effectively at long range
- Narrow, can fit in tight spaces
- Tall profile, bigger target
- Very thin armour, maximum of 15 mm
- Crew operating the gun have no armour protection in the top and rear of their position
- Not a lot of horsepower, poor for towing downed allied vehicles
- No defensive machine gun, open-top SPAA can be a problem
- Gun quickly becomes obsolete in uptiers, it does not cope well with sloped armour
The heavily armoured tanks in Allied inventory was considered a threat to the German armoured forces, which consisted of mostly 3.7 cm gun that were ineffective. To counter these threats, the Germans sought for a vehicle able to mount a bigger gun able to fight these tanks. It was found that they could convert obsolete chassis designs like the Panzer I to mount the guns, thus saving the design process of developing a new vehicle for the role. The Czech 4.7 cm Pak(t) anti-tank gun was chosen for this task, and was mounted on a converted Panzer I chassis with the turret removed, a gun shield was used for the mount of the gun. Between 1940 to 1941, 202 Panzer I’s were converted by Alkett and Deutz AG to these tank destroyers, designated the ‘’’Panzerjäger I‘’’, the first of its kind of tank destroyers in the war.
The Panzerjäger I were organised in anti-tank battalions, each having three companies with nine vehicles each. Five battalions in the war were equipped with the tank destroyer. The first usage of the Panzerjäger I was in the Battle of France, where four battalions were committed. Though, only Anti-Tank Battalion 521 saw service from the beginning to the end as the other four were still in training when the campaign started. The opinion of the crew of these vehicles were positive, saying that the weapon was adequate to distances up to 600 meters if the enemy had 45 to 50 mm of armour. However, the crew also say that the ability to observe the battle in the vehicle was terrible, the crew had to look over the shield to see what is ahead, risking themselves to injury to the head.
After the Battle of France, the Panzerjäger I's in Anti-Tank Battalion 605 were sent to the North African Campaign, though only 3 of the 27 vehicles made it as the transport freighter Castellon carrying the rest was sunk. The battalion was in full strength during the British offensive in Operation Crusader in November 1941, to which they lost 13 vehicles in the battle. Battle experience praise the accuracy the vehicle provides, but state that the vehicles were too weak for the combat conditions and the gun didn’t have enough penetration in long distance. With an APCR round, it was found it could destroy the venerable Matilda infantry tanks at distance of around 400 meters. The battalion continued this battle of attrition with reinforcement and losses that during the Second Battle of El Alamein in October 1942, only 11 Panzerjäger I’s were left in the battalion. The last two replacement vehicle were sent to the battalion in November 1942. In Operation Barbarossa, five anti-tank battalions were equipped with the Panzerjäger I’s, which made up a total of 135 vehicles. The combat experience was subpar, while the Panzerjäger I had a good effective range of up to 1,000 to 1,200 meters, but the high profile of the vehicle presented a big target to enemy anti-tank weapons and artillery, even shrapnels from high-explosive shells could penetrate the thin armour. Many Panzerjäger I’s were destroyed and by the Fall of 1942, many battalions reported to be under equipped for further action and were disbanded. At this point, better anti-tank weaponry and vehicles were more accessible and replaced the Panzerjäger I in service, notably the Marder series.
An excellent addition to the article will be video guides, as well as screenshots from the game and photos.
- [Devblog] The Panzerjäger I, and announcing a branch of German SPGs with open cabins
- [Profile] Panzerjäger I - The first German Tank Hunter
Paste links to sources and external resources, such as:
- topic on the official game forum;
- other literature.
|Germany tank destroyers|
|Based on Pz.38(t)||Marder III · Marder III H · Jagdpanzer 38(t)|
|Based on Pz.I||Panzerjäger I|
|Based on Pz.II||15cm sIG 33 B Sfl|
|Based on Pz.III||StuG III A · StuG III F · StuG III G · StuH 42 G|
|Based on Pz.IV||Jagdpanzer IV · Panzer IV/70(V) · Panzer IV/70(A) · Brummbär · Dicker Max · Nashorn|
|Based on Pz.V||Jagdpanther · Bfw. Jagdpanther|
|Based on Pz.VI||Sturer Emil · Ferdinand · Jagdtiger|
|JPz 4-5 · Waffenträger · VFW · VT1-2|
|Wheeled||8,8 cm Flak 37 Sfl. · Sd.Kfz.234/3 · Sd.Kfz.234/4|
|Rocket/Missile||15 cm Pz.W.42 · RakJPz 2 · RakJPz 2 (HOT)|