6 km/h back39 km/h forward
5 km/h backSpeed
|This page is about the tank destroyer Ho-Ni I. For the succeeding vehicle of similar name, see Ho-Ni III.|
The Type 1 Ho-Ni I is a Rank II Japanese tank destroyer with a battle rating of 2.0 (AB/RB/SB). It was introduced along with the entire Japanese Ground Forces tree in Update 1.65 "Way of the Samurai".
Similar in appearance to the Ho-Ro before it, it changes out the 150mm artillery cannon for a more traditional high-velocity gun, being one of the most powerful ones at its rank.
However, with no turret and very bad armor protection, it demands caution and patience, in exchange for being able to smash through even the heaviest tanks it faces. The fearsome Char B1, the terror of Rank I for example, is no match for the Ho-Ni. Play this tank with caution and you will be rewarded greatly.
Survivability and armour
The Ho-Ni I's excellent firepower and good mobility is balanced out by its very poor armor protection. The front of the hull is covered in unsloped 25mm plates, which is only sufficient to protect the tank from machinegun rounds - and even then some high-caliber guns (such as the 50 cal or DShK) can find their way through.
In addition, the gun compartment of the tank is uncovered, leaving the gunner and commander extremely vulnerable to artillery, machine guns, and aircraft attack. As the tank only has three crew members, the two being knocked out will leave the vehicle inoperable. Be sure to immediately retreat away from any artillery, preferably with your front facing the area being attacked, in order to protect the crew.
It is also important to try not to arouse the attention of enemy aircraft, as the open design means that any fighter plane can easily destroy you in a single strafe. With no machine gun, it does not have any means of fighting back against them either, so stay in the shadows!
- Rolled homogeneous armour
|Hull|| 25 mm (12-32°) Front plate
15 mm (63°), 17 mm (81°) Front glacis
15 mm (37-59°) Lower glacis
| 25 mm (40°) Top left
25 mm (24-27°) Top right
20 mm Bottom
| 17 mm (69°) Top
20 mm (4-72°) Bottom
|Superstructure||25 mm (14-15°)||25 mm (0-11°)||N/A||10 mm|
- Suspension wheels and tracks are both 15 mm thick
- Belly armour is 8.5 mm thick.
- Roof superstructure armour will not protect crew from strafe fire.
Thus, it has a fairly good level of mobility, reaching a peak speed of 36 km/h on flat grass in Realistic, with a theoretical maximum of 40km/h. It also has a quite good traverse rate, both on the hull and the gun, performing a full 360 degree rotation from a stop in about 16 seconds.
|Weight (tons)|| Add-on Armor
|Max speed (km/h)|
|Engine power (horsepower)|
|Power-to-weight ratio (hp/ton)|
Packing a high-velocity 75mm Type 90 Cannon, the Ho-Ni I has a serious amount of firepower at BR 2.0.
Its Type 1 APHE shell has up to 100mm of armor penetration, which is the second best of tank destroyers at its rank, only beaten by the Soviet ZiS-30, and being very closely followed by the American M3 GMC.
However, a cannon this big does come with two drawbacks; being that it has a fairly long reload time of 7.8 seconds, and no turret, meaning it can only aim in an arc in front of you. Thus, it is important that you make sure your shot lands, and that you are well aware of your surroundings, so that you do not end up wasting precious time turning your entire hull towards an enemy. You should play this tank as a support vehicle, hiding in bushes and shooting at targets at medium range. Chances are, you'll be able to penetrate and score one-shot after one-shot. You could also play as a sniper, if you are so inclined.
The Ho-Ni I does also not feature any machine guns, which leaves it unable to fight back against enemy aircraft or uncovered vehicles.
|75 mm Type 90|
|Turret rotation speed (°/s)|
|Mode||Stock||Upgraded||Prior + Full crew||Prior + Expert qualif.||Prior + Ace qualif.|
|Reloading rate (seconds)|
|Stock||Prior + Full crew||Prior + Expert qualif.||Prior + Ace qualif.|
|Ammunition|| Type of
|Penetration in mm @ 0° Angle of Attack|
|Type 1 APHE||APHE||97||93||83||71||61||51|
|Type 94 HE||HE||11||11||11||11||11||11|
|Ammunition|| Type of
Mass in kg
| Fuse delay
| Fuse sensitivity
| Explosive Mass in g
| Normalization At 30°
|Type 1 APHE||APHE||668||6.6||1.3||15||67.84||-1°||47°||60°||65°|
|Type 94 HE||HE||522||6.0||0.1||0.1||810||+0°||79°||80°||81°|
Mass in kg
| Screen radius
| Screen time
| Screen hold time
| Explosive Mass in g|
|Type 90 Smoke||570||5.7||13||5||20||100|
|40||37 (+3)||24 (+16)||1 (+39)||no|
Usage in battles
The Ho-Ni I should be played like most open crew compartment, fixed gun tank destroyers, fighting from a distance from the front-lines and delivering support fire. The thin armour means the Ho-Ni I will not survive a direct confrontation with any enemy tank and will require the vehicle to obtain the fighting advantage of being able to target the enemy first to ensure any chance of victory. The Ho-Ni I should also be wary of enemy aerial attacks as the open compartment and three-man crew means that an accurate strafing fire could potentially knock out the entire crew.
At its battle rating, the worst the Ho-Ni I could face are the German Pz.IV E and British Cromwell V and Matilda Mk II. The two medium tanks have sufficient armour to withstand the 75 mm gun while the Matilda II requires precise shot in order to destroy it frontally - the driver's port. All of these tanks have guns able to shred the Ho-Ni I apart if they could get a bead on it. The Char B1 can also be a challenge, the only way to deal with it head on is by shooting the driver's port, which will require making you vulnerable to the powerful 75mm hull gun that tank has.
Pros and cons
- 75 mm cannon is great, reloads fast and causes massive damages upon penetration
- Favorable matchmaking will leave the tank destroyer being matched with enemies the gun is able to handle
- Mobility is decent due to being built on a Chi-Ha chassis
- Gun is able to effectively penetrate all tanks the Ho-Ni regularly faces frontally
- Similar play style as the German Marder with better gun depression
- Good gun traverse speed
- Powerful HE shell
- Has smoke shells
- Tall profile
- Overall armour is thin
- Poor cross country performance due to narrow tracks
- Exposed crew space makes it vulnerable to air attacks
- Reverse speed is abysmal
- Only 3 crew members
- Rather small traverse angle
The creation of their own independent armoured division had Japan also envision an enlargement of their artillery forces. They decided to build a series of assault guns based off the Type 97 Chi-Ha chassis. One of the first of these design was the Ho-Ni I which had the Type 97 chassis fitted with a 75 mm Type 90 field gun.
The Ho-Ni I was used in China by the 3rd Tank Division and on Luzon by the 2nd Tank Division. It could be used as mechanized artillery or as a tank destroyer/assault gun. A total of 124 were built.
Skin and Camouflages for the Ho-Ni I in Warthunder Live.
- Zaloga Steven. Japanese Tanks 1939-1945 Great Britain: Osprey Publishing Ltd., 2007
Links to the articles on the War Thunder Wiki that you think will be useful for the reader, for example:
- reference to the series of the vehicles;
- links to approximate analogues of other nations and research trees.
|Japan tank destroyers|
|Based on Chi-Ha||Type 1 Ho-Ni I · Type 3 Ho-Ni III · Type 4 Ho-Ro|
|Based on Ho-Ri||Type 5 Ho-Ri Production · Type 5 Ho-Ri Prototype|
|Type 5 Na-To|
|Post-war||Type 60 SPRG (C) · Type 60 ATM · Type 75 MLRS · Type 75 SPH · Type 16|