The FV4004 Conway is a rank IV British tank destroyer with a battle rating of 7.0 (AB/RB/SB). It was introduced in Update 1.57 "Battle March". It is armed with a cannon developed to take on the heavy Soviet IS-3 tank. It excels in fighting the top-rank heavies.
This tank plays very similarly to the KV-2. It lacks armor on all sides and has a very large caliber gun, able to penetrate everything it faces, severely damaging most. It can be played as a usual tank destroyer, excelling at it with its high velocity APDS rounds, sniping from a distance. Extraordinarily, it is also able to take a heavy tank in a 1v1 as well.
Survivability and armour
- Rolled homogeneous armour
- Cast homogeneous armour (Gun mantlet)
|Hull|| 76.2 mm (58°) Front glacis
76.2 mm (47-48°) Lower glacis
|50.8 (12°) + 6 mm||38 mm (8-12°)|| 29 mm |
8-14 mm Engine deck
|Turret|| 132 mm (19°) Turret front
140 mm (7-61°) Gun Mantlet
| 95 mm (0-6°) Front
47 mm (2°) Middle
30 mm Rear
| 30 mm Border
20 mm Hatch
|Cupola||47 mm||47 mm Right side 30 mm Left & Rear||47 mm|
- Suspension wheels are 20 mm thick while tracks are 30 mm thick.
- Turret sides are angled, causing inaccurate shots to bounce.
|Game Mode||Max Speed (km/h)||Weight (tons)||Engine power (horsepower)||Power-to-weight ratio (hp/ton)|
Modifications and economy
The first upgrades to research are Parts and FPE for increased survivability. Once you got these two, go for Adjustment of Fire and Elevation Mechanism, since these modules increase the accuracy of the gun.
|120 mm Ordnance QF Tk. L1A2||Turret rotation speed (°/s)||Reloading rate (seconds)|
|Ammunition|| Type of
|Penetration @ 0° Angle of Attack (mm)|
|10 m||100 m||500 m||1,000 m||1,500 m||2,000 m|
|Ammunition|| Type of
| Fuse delay
| Fuse sensitivity
| Explosive Mass
(TNT equivalent) (g)
| 18 (+2)
| 17 (+3)
| 5 (+15)
| 1 (+19)
- The Conway uses two-piece ammunition, composed of projectiles (yellow) and propellant bags (orange). Both have separate racks.
- Projectile and propellant racks 4 are first-stage ammo racks.
|7.62 mm L3A1|
|Mount||Capacity (Belt)||Fire rate||Vertical||Horizontal|
Usage in battles
As a tank destroyer, you might want to go for heavy tank hunt. In this case, you should check the battle rating of opposing team. Despite having heavy gun, your best bet in uptier would be long range flank sniping. This is due to APDS doing less damage to crew and components, the thicker the armor it penetrated was, thus doing minimal damage through heavy tank's frontal armour. As such, you are less dangerous to superheavy tanks (especially the ones from 8.0) from front, compared to FV 4005, which many players will mistake you for. You still can penetrate most of breakthrough tanks, forcing them to retreat or slip up at critical moment. Since APDS is super high velocity, you can snipe across the map with little issue, and do fatal damage from sides.
To everything else you are extremely dangerous, and, if detected, have some presence factor. This can be beneficial and bad at same time, since you can scare off heavy tanks and attract medium and light tanks, and even other SPG's. Your turret might hold off a few stray shots from distant or weak opponents, but your hull is still quite fragile, and reload times are still too long, so there is no room for mistakes at close range duels. For these reasons, if possible, adversaries must be kept away from you, so their guns are inadequate at fighting you, your hull must be kept hidden, and enemy SPG and "sniper" oriented medium tanks must be neutralized on sight.
In case if light vehicle is stalking you, sometimes it's better to just load HESH, provoke, then hopefully blast enemy away. Heavily armoured vehicles are still more vulnerable to APDS, than HESH, regardless of range, unless you hit them at specific weakspots with it.
Pros and cons
- Very powerful 120 mm gun.
- Excellent long range support thanks to the high muzzle velocity for the APDS shells
- Weak armour overall.
- Low mobility
- Tall profile
- Only carries a maximum of 20 shells.
- Long reload time.
- Insufficient gun depression
When the Centurion tanks entered service in British service in 1945, the British didn't tank account to the sudden appearance of the Soviet IS-3. The IS-3 tank showed the Western Allies needed to reconsider their tank inventories, which at the time the IS-3 was introduced only composed of mostly M4 Shermans, M26 Pershings, and the Centurions. The British, recognizing the need of a bigger gun to fight the IS-3, started production on the Conqueror. However, development takes time and the Conqueror would not be ready until 1955. As an interim project until it is done, the British took a Centurion Mk 3 tank and upgraded with a new turret made from rolled plate that can mount the 120 mm L1 gun, the same gun meant for the Conqueror. This vehicle, designated the FV4004 Conway was to have the heavy armament, yet the same maneuverability as the base Centurion. One of such vehicle was made in this matter before the whole thing was cancelled in 1951. The sole piece made is now stored in the Bovington Tank Museum.
Another attempt at this kind of mounting with the Centurion was the FV4005, which was meant to be a tank destroyer with a larger 183 mm gun. The project started in 1951 and developed in July 1955. The gun was mounted in a similar fashion as the Conway on a lightly armoured turret. This was a limited production and by August 1957, the whole project was disassembled. The FV4005 also has survived in the Bovington Tank Museum.
Links to the articles on the War Thunder Wiki that you think will be useful for the reader, for example:
- reference to the series of the vehicles;
- links to approximate analogues of other nations and research trees.
|Britain tank destroyers|
|Infantry Tank Derivatives||Archer · Gun Carrier (3-in)|
|M10 Achilles||Achilles · Achilles (65 Rg.)|
|Post-war||FV4005 · Conway|
|ATGM||Swingfire · Striker|
|Canada||QF 3.7 Ram · ADATS (M113)|