Difference between revisions of "105/25 M43"
m (→Pros and cons)
|Line 123:||Line 123:|
=== Pros and cons ===
=== Pros and cons ===
Summarize and briefly evaluate the vehicle in terms of its characteristics and combat effectiveness. Mark its pros and cons in a bulleted list. Try not to use more than 6 points for each of the characteristics. Avoid using categorical definitions such as "bad", "good" and the like - they have a substitution in the form of softer "inadequate", "effective".
Latest revision as of 02:01, 22 September 2019
5 km/h back37 km/h forward
4 km/h backSpeed
|This page is about the Italian tank destroyer 105/25 M43. For premium version, see 105/25 M43 "G.C.Leoncello".|
The Semovente 105/25 M43 is a rank III Italian tank destroyer with a battle rating of 3.0 (AB/RB/SB). This vehicle was introduced in Update 1.85 "Supersonic".
Survivability and armour
Describe armour protection. Note the most well protected and key weak areas. Appreciate the layout of modules as well as the number and location of crew members. Is the level of armour protection sufficient, is the placement of modules helpful for survival in combat?
If necessary use a visual template to indicate the most secure and weak zones of the armour.
Write about the mobility of the ground vehicle. Estimate the specific power and manoeuvrability as well as the maximum speed forward and backwards.
|105 mm Cannone Ansaldo da 105/25|
|Turret rotation speed (°/s)|
|Mode||Stock||Upgraded||Prior + Full crew||Prior + Expert qualif.||Prior + Ace qualif.|
|Reloading rate (seconds)|
|Stock||Prior + Full crew||Prior + Expert qualif.||Prior + Ace qualif.|
|Ammunition|| Type of
|Penetration in mm @ 90°|
|Granata Perforante da 105||APC||90||88||80||71||63||56|
|Effeto Pronto mod.43||HEAT||120||120||120||120||120||120|
|Ammunition|| Type of
Mass in kg
| Fuse delay
| Fuse sensitivity
| Explosive Mass in g
| Normalization At 30°
|Granata Perforante da 105||APC||500||16||0.8||28||275||°||48°||63°||71°|
|Effeto Pronto mod.43||HEAT||510||14||0.0||0.1||1.8||°||62°||69°||73°|
|48||XX (+XX)||XX (+XX)||XX (+XX)||No|
Usage in battles
Describe the tactics of playing in the vehicle, the features of using vehicles in the team and advice on tactics. Refrain from creating a "guide" - do not impose a single point of view but give the reader food for thought. Describe the most dangerous enemies and give recommendations on fighting them. If necessary, note the specifics of the game in different modes (AB, RB, SB).
Pros and cons
- Hard-hitting 105 mm gun
- Small profile = harder for enemies to spot
- Has access to HEAT rounds
- Respectable frontal armour
- Decent mobility overall
- Decent gun depression of -10 degrees
- As with all casemate tank destroyers, it is vulnerable to getting flanked
- No machine gun
- Somewhat long reload, can be drastically increased if a crew member gets knocked out
- Only 3 crew members
- Can be vulnerable to planes strafing from above
- No HE rounds to deal with lightly armoured vehicles
In mid-1942, the Italian Army put out a set of requirements for a new vehicle that could double up as both an infantry support vehicle as well as a tank destroyer, depending on the situation. In response to this, Fiat-Ansaldo and OTO both began developing prototypes around these requirements in parallel.
The two competing designs primarily differed in the chassis choice. OTO picked the newer chassis of the P40 heavy tank whilst Fiat-Ansaldo chose to opt for a newer and larger version of the chassis already in production for their Semovente M42.
This decision allowed Fiat-Ansaldo to complete their prototype much sooner. In February 1943, the Semovente 105/25 M43 was presented to military officials and was soon afterwards ordered into production, following successful trials.
Production began in April 1943, with a planned production run of over 800 vehicles. However, with Italy’s industry at this late stage of the war being severely crippled, production was slow and reaching such high production goals was more than unlikely.
Just prior to the signing of the armistice in September, the 30th vehicle rolled off the assembly line. The Semovente 105/25 M43 proved itself in combat during the defence of Rome, where the SPGs successfully engaged German forces trying to retake the city.
After the occupation of northern Italy by German forces, the Fiat-Ansaldo company restarted production of the Semovente 105/25, this time however, for the Germans. Germany only used a limited number of these vehicles under the designation Sturmgeschütz M43 mit 105/25 853(i), of which most were no longer in use by late 1944.
Around 120 Semovente 105/25 M43s were built by 1944, primarily serving with Italian or German forces. By the late stages of the war, only a limited number was still in service and after the end of WW2, the vehicle was retired from service.
- From Devblog
Skin and Camouflages for the 105/25 M43 in Warthunder Live.
Links to the articles on the War Thunder Wiki that you think will be useful for the reader, for example:
- reference to the series of the vehicles;
- links to approximate analogues of other nations and research trees.
|Italy tank destroyers|
|Casemate||L3/33 CC · 47/32 L40 · 75/18 M41 · 75/32 M41 · 75/34 M42 · 90/53 M41M · 105/25 M43 · M43 "G.C.Leoncello" · 75/34 M43 · 75/46 M43|
|Centauro||Centauro · Centauro ROMOR|
|Breda 501 · M36B1 · M113A1 (TOW)|