Pz.III J1

Pz.III J1

Pz.III L

Pz.III J1

Pz.III L

Germany

II Rank

Battle rating:

AB	RB	SB
2.7	2.7	2.7

Class:

Medium tank

Research:7 900

Purchase:10 000

Show in game

Description

The Pz.Kpfw. III Ausf. J1 (Panzer III J1) is a Rank II German medium tank with a battle rating of 3.0 (AB/RB/SB). It was introduced in Update 1.43. An improvement over the J version with the longer 50 mm KwK 39 gun, the Panzer III J1 provides a better punch.

This variant, compared to its predecessor - Pz.III J, features only few, but very important upgrades.

Most importantly, J1 variant is the first Panzer III to have the long barreled KwK 39 L/60 50mm tank gun. This gun offers 96mm of armour penetration at range of 100 m and 79mm at 500m. In practical sense, it is just enough to deal with most tanks at this BR, although targeting weakspots, or side/rear armour is often necessary. Heavy tanks like KV-1 are quite problematic, but that is why you have APCR ammunition. APCR comes in two set, PzGr40 and PzGr40/1. PzGr40 has the highest penetration - 150mm at close range, but loses penetration quite rapidly when shooting far targets. (->More info can be found below in the "Ammunition" section.)

Second important upgrade is the electric turret drive - greatly improving the turret traverse speed, and removing the long present weakness of all older Panzer III variants.

Optimal combat distance for this vehicle is somewhere between medium to close range. But don't be mistaken, Panzer III J1 is not an frontline tank. You should be always on the move and harass the enemy without rest as any return fire will be lethal. Don't trust your armour and instead rely on your mobility. Flanking is the best option for J1 as you can use the high RoF for good effect and hopefully avoid the incoming retribution. You don't have the best mobility for medium tank, but you definitely remain competitive against most enemy tanks you may encounter. Always try to find some good firing positions, with available cover, and if necessary, pull back and relocate. Always avoid direct close range confrontations with main enemy force, never try to fight more than 1 enemy at the time. However - playing purely as support/sniper tank isn't optimal either, because of your lower armour penetration.

General info

Survivability and armour

Armour type:

• Rolled homogeneous armour
• Cast homogeneous armour (Barrel shroud, Cupola)

Armour	Front	Sides	Rear	Roof
Hull	50 mm (12°) Front plate 25 mm (86°), 50 mm (53°) Front glacis 50 mm (23-69°) Lower glacis	30 mm	50 mm (15-41°) Top 50 mm (11-66°) Bottom	15 mm
Turret	50 mm (12-25°) Turret front 50 mm (12-46°) Gun mantlet	30 mm (22-25°)	30 mm (13-16°)	10 mm
Cupola	50 mm	10 mm

Notes:

• Suspension wheels are 15 mm thick while tracks are 20 mm thick.

Mobility

Mobility characteristic
Weight (tons)	Add-on Armor weight (tons)	Max speed (km/h)
21.8	N/A	59 (AB)
		53 (RB/SB)
Engine power (horsepower)
Mode	Stock	Upgraded
Arcade	465	572
Realistic/Simulator	265	300
Power-to-weight ratio (hp/ton)
Mode	Stock	Upgraded
Arcade	21.33	26.24
Realistic/Simulator	12.16	13.76

Armaments

Main armament

50 mm KwK 39
Capacity			Vertical guidance	Horizontal guidance	Stabilizer
92			-10°/+20°	±180°	N/A
Turret rotation speed (°/s)
Mode	Stock	Upgraded	Prior + Full crew	Prior + Expert qualif.	Prior + Ace qualif.
Arcade	8.30	11.53	_.__	_.__	_.__
Realistic	8.30	9.80	_.__	_.__	_.__
Reloading rate (seconds)
Stock	Prior + Full crew	Prior + Expert qualif.	Prior + Ace qualif.
4.80	_.__	_.__	_.__

Ammunition

Penetration statistics
Ammunition	Type of warhead	Penetration in mm @ 90°
		10m	100m	500m	1000m	1500m	2000m
PzGr 39	APC	97	96	79	62	49	38
Sprgr. 38	HE	4	4	4	4	4	4
PzGr 40/1	APCR	128	126	91	61	40	27
PzGr 40	APCR	150	149	108	72	48	32

Shell details
Ammunition	Type of warhead	Velocity in m/s	Projectile Mass in kg	Fuse delay in m:	Fuse sensitivity in mm:	Explosive Mass in g (TNT equivalent):	Normalization At 30° from horizontal:	Ricochet:
								0%	50%	100%
PzGr 39	APC	835	2.1	1.2	25	45.9	-1°	48°	63°	71°
Sprgr. 38	HE	550	1.8	2.0	0.1	170	+0°	79°	80°	81°
PzGr 40/1	APCR	1140	1.1	N/A	N/A	N/A	+1.5°	66°	70°	72°
PzGr 40	APCR	1180	0.93	N/A	N/A	N/A	+1.5°	66°	70°	72°

Shell types

• PzGr 39 - Armour Piercing Capped shell - This is your main ammo type, use it whenever you think it has enough penetration to penetrate your target. It deals most damage, because of its explosive filler.
• PzGr 40/1 - Armour Piercing Composite Rigid shell - This type of ammo should be used if you are having trouble penetrating your opponent, or trying to hit a fast moving tank at some distance. However, its damaging potential is much lower, because it has no explosive filler to further enhance damage after the penetration.
• PzGr 40 - Armour Piercing Composite Rigid shell - this variation of APCR is lighter, slightly faster and offers best penetration. Use it against heavily armoured tanks like KV-1 (If you can't flank them). However, don't expect it to cause any real damage upon penetration, it is even worse than that of PzGr 40/1. It basically only deals damage to modules/crew straight in its path. It is therefore almost useless to fire them at things like turret cupolas, as it will usually just fly right through them.
• SprGr 38 - High Explosive ammo - You should carry only very few of these. They are completely useless against anything other than unarmoured AA vehicles, to which it is lethal.

Ammo racks

Ammo racks of the Panzer III J1.

Full ammo	1st rack empty	2nd rack empty	3rd rack empty	4th rack empty	Visual discrepancy
92	70 (+22)	47 (+45)	24 (+68)	1 (+91)	Yes

Turret empty: 70 (+22)

Machine guns

7.92 mm MG 34
Coaxial mount
Capacity (Belt capacity)				Fire rate (shots/minute)	Vertical guidance	Horizontal guidance
3,750 (150)				900	N/A	N/A

Usage in the battles

First of all, lets talk about the gun. The 5 cm KwK 39 is a good gun in the right circumstances. Its main round, the PzGr 39 Armour Piercing Capped has average penetration for the BR, but causes little post penetration damage. Granted, if you fire it into a tightly packed turret, it will knock out the crew, but larger vehicles can be an issue. Then there is the PzGr 40 Armour Piercing Composite Rigid (APCR) round, which has high penetration (150mm!), but causes very little internal damage and performs poorly against sloped armour. It also loses its penetration quickly at range. It is best to carry both of these types of ammunition, allowing you to combat different targets more effectively.

Luckily, the KwK 39 has a saving grace. With a reload time of just under 5 seconds, it fires very quickly. This gun performs effectively in flanking maneuvers, where you can take advantage of weak side armour. Precise aim is necessary, as this gun rarely destroys a target in one shot. Normally you have a choice. Do you shoot the driver and immobilize the tank and then incapacitate the gunners? Or do you knock out the gunners first and then take out the driver? Most of the time, it is best to take out the gunners first, so that the tank cannot shoot back. However, if the tank is mobile and the turret is facing another direction, it is sometimes best to take out the driver first. This way the tank won't have a chance to find cover.

The armour of the Panzer III is poor. It is flat, and at 50 mm it won't protect you from even rank 1 guns. From the sides you are vulnerable to anything above a .50 cal machine gun. Avoid frontal engagements with M4 Shermans and T-34s. You are unlikely to be able to destroy them quickly, and often your rounds will ricochet off their sloped armour. Their rounds will slice through your armour like butter and often defeat your entire crew after a single penetration. Thus, this tank is best in a support/sniping role.

Pros and cons

Pros:

• High RoF (Rate of Fire).
• High shell velocity.
• Mobile and fast.
• Excellent gun depression.
• APCR ammo is great against moving targets.

Cons:

• Poor damage against modules and crew.
• Gun lacks penetration at range, is likely to bounce from slopes, and isn't very accurate.
• Overall weak armour.
• Modules are sensitive to damage.

History

Development

The Panzerkampfwagen III medium tank, or the Panzer III was developed in the 1930s. Starting in early 1934, Heinz Guderian set down some specifications for a new tank, which Army Weapons Department took up to design the tank to weigh no more than 24,000 kilograms with a top speed of 35 km per hour. This tank's role was to be the main tank of the German army and was expected to destroy opposing tanks, as opposed as a tank made to destroy anti-tank guns and opposing infantrymen, which the Panzer IV took up in.

Damlier-Benz, Krupp, MAN, and Rheinmetall produced prototypes meeting the specifications and the Damlier-Benz model was chosen after testing in 1936-1937. The Panzer III model used a leaf-spring suspension in its early models (Ausf. A - Ausf. D) before utilizing a six-wheeled torsion-bar suspension in the Ausf. E and beyond. The Panzer III had a crew of five people, the commander, gunner, loader, driver, and assistant driver. The best feature of the Panzer III during its introduction that is the most overlooked was the three-man turret, which was not as common at the time. This frees the commander to be able to effectively command the tank while maintaining situational awareness rather than be burdened by the role of a loader or gunner, improving combat effectiveness of the tank. Despite this rather advance design, the turret did not have a turret basket for the crew. It was a proven design and production began in May 1937. The total number of Panzer IIIs tanks constructed in its production life was 5,774 units (excluding StuG III variant).

Specifications

The Panzer III Ausf. J1 features a much better 50 mm gun compared to its predecessors, the 50 mm KwK 39, which is an improvement over the 50 mm KwK 38 by its longer barrel, giving a much better muzzle velocity to fired shell and therefore better penetration values. This new 50 mm gun gives the Panzer III a fighting edge against T-34s and M4 Shermans, which the older 50 mm KwK 38 had trouble fighting against. The Panzer III Ausf. J1 still featured the 50 mm armour thickness on the front and rear originally from the Ausf. J variant, but later models has new offset armour on the front of the hull and turret that are 20 mm effective. These armour also apply as spaced armour due to not being attached to the hull or turret mantlet. The spaced armour on the front helped defend the tank against Soviet anti-tank rounds or HEAT rounds fired at it on those plates, as it dissipates the penetration power before striking the hull.

Combat usage

The Panzer III J1 was only a stopgap design to integrate the 50 mm KwK 39 into service as fast as possible. The final designs in its later models were later redesignated the Panzer III Ausf. L.

Media

Skins and camouflages for the Panzer III Ausf. J1 from live.warthunder.com. There are plenty of category terms flying around. So looking through every one of them will be necessary. Some of these might not work. Look for the Panzer 3 tanks with the very long barrel, or see what the description says.

• #panzer_iii_j1

Sights

• RideR2's Realistic gunsight (TZF4a, TZF 5a/b/d/e/f/f2, TZF 9b/b1/c/d, TZF 12/a) for Pzkpfw II, Pzkpfw III, Pzkpfw IV, Pzkpfw V, Pzkpfw VI

Read also

Links to the articles on the War Thunder Wiki that you think will be useful for the reader, for example,

• reference to the series of the vehicles;
• links to approximate analogues of other nations and research trees.

ETC.

Sources

Paste links to sources and external resources, such as:

• topic on the official game forum;
• other literature.